B15 Sentra Forum banner
21 - 36 of 36 Posts

·
Registered
Joined
·
702 Posts
Discussion Starter · #24 ·
Some pics taken on Friday of the X while it was being worked on at the shop. Enjoy!




Added the following:

JWT BSR Kit
JWT Camshafts
SWA Pulley
Outlaw Engineering Thermoblock Spacers
Axxtion SS
JWT Flywheel
JWT Clutch
Filled Motor Mounts
Grounding Kit
Voltage Stabilizer
Apexi Super AFC II Black
Redline MTL90/MTL Transmision Oil Mix
Redline Water Wetter
Blue Line Clutch Fluid
Mobil 1 Synthetic Oil
 

·
Registered
Joined
·
702 Posts
Discussion Starter · #30 ·
New Pics!




Added:

Arospeed Riot Polished/Gunmetal 18x7.5' wheels
Toyo Proxes 255/55R18 tires
Outlaw Engineering intake manifold & throttle body gaskets
Grounding kit
Voltage stabilizer
JWT balance shaft remover kit
JWT Camshafts
Southwest Autoworks pulley
Apexi Super AFC II Black
JWT clutch
JWT flywheel
Redline MTL/MTL-90 Transmission Oil Mix
Blue Line Clutch Fluid

Had the truck dyno tuned to 172whp & 169lbs-ft. Going back later in the month since I know I can squeeze out some more.

Mods due later this month to be installed:

NOS Wet 50 or 75 shot (have the jets for both)
NGK 1-Step Colder Spark Plugs
Re-install Knock Sensor in Stock Location
 

·
Registered
Joined
·
702 Posts
Discussion Starter · #32 ·
Yep, same 5-speed. Only difference is in the housing, since I have an output shaft going to the rear wheels, It also has a small transfer case attached which changes the shifters mechanism. I found this out the hard way when I went to install the Axxtion SS.

Curb weight is stated at 1440kg. However, I run around with no interior from the front seats to the back :D
 

·
Registered
Joined
·
1 Posts
@Terranismo wondering if u could post updated pics of ur x trail I have started a identical project coincidently and would like to see all your mods ! I can’t message you for Some reason but any insight would be much appreciated
 
21 - 36 of 36 Posts
Top