B15 Sentra Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I've attached 2 pictures. On one, why do I have a spring loaded switch on the driver's side that would activate when the hood is open or close? 2, on the other picture, I just noticed that wire which appears to have once been attached to a prong and that prong broke off in the clip. The other end of that wire is secured to the inner fender well with a ring terminal. That wire is under the battery tray. If anyone knows the purpose of either of these, please try to help. Thank you.
P.s., that wire is most likely a ground and if it broke recently, that would explain my codes that were different every time that I deleted them then re-read them.
Also, the wire to that spring loaded switch runs into the factory wire harness.
Hood Gesture Automotive tire Automotive exterior Elbow

Motor vehicle Hood Automotive tire Automotive design Tread

Automotive lighting Hood Motor vehicle Automotive design Automotive tire
 
1 - 1 of 1 Posts
Top